![]() I'm not sure if my ISP has changed my public IP between the time we set this up until today, but even if they did, I would think resetting the protocol adapter would cause it to phone home again and update the IP address.Īnyone have any ideas? Considering I was able to connect on day 1, I don't think this is a firewall or router config issue but am open to suggestions. 1 Pentair screenlogic not connecting manual Pentairs ScreenLogic Connect is. I realize the protocol adapter phones home to Pentair, and reports the public IP of my router, and then uses this to allow remote connection. I have a static IP address assigned to it in my router as well. I've already tried unplugging and replugging the power to the protocol adapter, and it hasn't worked. Prior to hanging on "Requesting gateway connection", I can see other messages flashing, but it's too fast to be able to read them. ![]() I've tried several times, and it hangs on "Requesting gateway connection " for a minute or so, then displays the error. but when I tried, I get "ERROR: Cannot connect" so I thought, -I can answer that Just log into ScreenLogic. my wife made a comment "I'd really like to swim today, I wonder what the water temp is?". When we initially installed the ScreenLogic setup, I used my phone to connect to it remotely (ie: I shut my phone's WiFi off, and connected over the Since then, I've been connecting locally (while on my home's WiFi) and all has been fine. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |